Table of Contents
Advertisement
User instructions
Repeat & Random playback
Should you wish to play an entire disc in a random
order or simply repeat a single track or entire disc,
follow the below steps .
1: During playback of a CD, press the REPEAT button (6) .
After one press you will see a dot on the right of the
display flash, to indicate the current track will repeat .
2: Press the REPEAT button (6) again and the dot on the
right of the display will stop flashing . This indicates
the entire disc will repeat .
3: Press the REPEAT button (6) once more, you will see
the dot disappear from the display to indicate no
REPEAT function is active .
Programmed playback
To program an alternative playback order of tracks
follow the below steps .
1: Make sure the unit is not playing a disc .
2: Press the PROGRAM button (10) once . The program
sequence "01" appears on the LED display & the
PROGRAM LED indicator (9) flashes .
3: Select the first track to be programmed using either
SKIP
button (5) or PREVIOUS
4: Press the PROGRAM button (10) again to store and
advance to the next programmed track .
The program sequence indication changes to "02"
momentarily waiting for your next input .
5: Repeat the steps above to program more tracks .
A maximum of 20 tracks can be programmed .
6: Press the PLAY/PAUSE button (11) to begin the
programmed playback in the preferred order .
7: You can press the STOP button (12) to terminate
programmed playback .
Radio operation
1: Wake the unit from STANDBY mode if required .
2: Slide the FUNCTION switch (18) to the RADIO/LINE
IN position .
3: Extend the antenna fully, and angle for best reception
(you may need to adjust once tuned to a station) .
4: Set the RADIO BAND switch (15) to either FM or MW .
5: Tune to the required station using the TUNING DIAL
(14) .
NOTE: When receiving an FM broadcast, fully
extend the telescopic antenna and angle it for the
best reception.
Radio operation (cont)
5: Adjust the volume to a comfortable listening level
using the volume control (2) .
Aux audio input
Connect an external audio source like an MP3 player
using a 3 .5mm audio cable (not supplied) .
1: Connect one end of the cable to the MP3 players
headphone output and the other end to the AUX LINE
INPUT socket (17) on the rear of the unit .
MW
button (7) .
2: Wake the unit from STANDBY mode if required .
3: Set the FUNCTION switch (18) to the RADIO/LINE IN
position .
NOTE: When a 3.5mm audio cable is connected
to the LINE-IN socket, radio output will be muted
until the cable is removed.
4: Press PLAY on the external audio source EG:-MP3
player .
NOTE: the volume output is effected by the
volume level on the source EG: MP3 player so
make sure that is set to about 70-80% ( not too
loud to avoid distortion ) .
5: Adjust the VOLUME control on the unit to the required
listening level .
Page 5
Advertisement
Table of Contents
