Table of Contents
Advertisement
Installation
Battery installation (cont)
NOTE: The mains cable must be detached
from the AC mains socket of the player for the
batteries to power the unit.
Leaking batteries may damage the battery
cabinet and the player as a whole, so they should
be removed from the cabinet when becoming flat
or when the player is not to be used with batteries
for some time.
Mains operation
This unit is supplied with a DC mains cable.
1: To connect the power insert the mains cable figure
eight plug into the rear of the unit (16) .
2: Insert the UK plug into a household power socket and
switch the power ON .
Power modes
Follow the below steps to power the unit off or enter
standby mode .
1: To power the unit OFF, slide the FUNCTION switch
(18) to the OFF position .
2: To enter STANDBY mode (power saving) press and
hold the PLAY/PAUSE/ECO PWR button (11) for 5
seconds .
3: To wake the unit from STANDBY mode press the
PLAY/PAUSE/ECO PWR button (11) once .
AUTO STANDBY Due to new ECO regulation
requirements this product incorporates a power
saving feature.
When in CD mode or AUX mode, once audio
playback has ceased and the unit has stood idle
for approximately 20 minutes it will switch into a
'power-down' power saving mode.
THIS IS NOT A FAULT .
To wake the unit up, press the PLAY/PAUSE/ECO
PWR button (11).
Page 4
Volume control
1: To increase the volume level rotate the VOLUME
control (2) clockwise .
2: To decrease the volume level rotate the VOLUME
control (2) Anti-clockwise .
CD operation
Load a CD
1: Open the CD door by lifting the raised part of the lid
(front above the display) upwards .
2: Load a CD onto the disc tray with the label facing
upwards you .
3: Close the CD door .
Playing a CD
1: Wake the unit from STANDBY mode if required .
2: Slide the FUNCTION switch (18) to the CD position .
3: Follow the steps above to load a disc (if not loaded) .
4: The player begins to read the disc immediately .
5: When the disc is successfully read the total number
of tracks found on the disc will be displayed .
6: Press the PLAY/PAUSE button (11) once to begin
playback . Press again to PAUSE the music playback,
a dot flashes on the display to indicate the player is in
Pause mode . Pressing the PLAY/PAUSE button (11)
resumes playback .
7: Press the STOP button (12) to cease music playback .
the display shows the total number of tracks again .
Skip & search tracks
1: Press the SKIP
button (5) once during playback
to skip to the next track . To skip to a specific track
ahead, press this button several times until you reach
the track number required .
2: Press the PREVIOUS
playback to return to the beginning of the current
track . Press the PREVIOUS
repeatedly to skip to the previous track . To skip back
to a specific track, press this button several times .
3: Hold the SKIP
button (5) during playback to fast
forward the current track .
4: Hold the PREVIOUS
fast rewind the current track .
button (7) once during
button (7) twice
button (7) during playback to
Advertisement
Table of Contents
