Advertisement
WLF013P ManualEN 051508.qxp
5/15/2008
SAFETY GUIDELINES / DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in property damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always be followed to reduce the risk of
personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and property
damage. There are certain applications for which tools and equipment are designed. Black & Decker strongly recommends that this
product NOT be modified and/or used for any application other than for which it was designed. Read and understand all warnings and
operating instructions before using any tool or equipment.
IMPORTANT SAFETY INSTRUCTIONS
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating product. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
• AVOID DANGEROUS ENVIRONMENTS: Don't use light in damp or wet locations. Don't use light in the rain.
• STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be stored indoors in dry, and high or locked-up
place – out of reach of children – to avoid the risk of damaging the appliance.
• DON'T FORCE APPLIANCE. It will do the job better and with less likelihood of a risk of injury at the rate for which it was
designed.
• DON'T ABUSE CORD. Never carry light by the charger cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp
edges.
• DON'T OVERREACH. Keep proper footing and balance at all times.
• DISCONNECT APPLIANCES. Disconnect the 120 Volt AC Charger from the power supply when not in use.
• GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be provided on the circuits or outlets to be used.
Receptacles are available having built in GFCI protection and may be used for this measure of safety. Charger plug must match
the outlet. Never modify the plug in any way.
• USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or attachment not recommended for use with this light
could be hazardous.
Note: Refer to the "Accessories" section of this manual for further details.
• STAY ALERT. Watch what you are doing. Use common sense. Do not operate appliance when you are tired.
• CHECK DAMAGED PARTS. Before further use of the appliance, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other
part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated
elsewhere in this instruction manual. Have defective switches replaced by authorized service center. Do not use appliance if
switch does not turn it ON and OFF.
• EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one
heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss
of power and overheating. The accompanying table shows the correct size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
Minimum Gage for Cord Sets
Volts
120V
0-25
(0-7,6m)
240V
0-50
(0-15,2m) (15,2-30,4m)
Ampere Rating
More
Not more
Than
Than
0 -
6
18
6 -
10
18
10 -
12
16
12 -
16
14
• OUTDOOR USE EXTENSION CORDS. When appliance is charged outdoors, use only extension cords intended for use outdoors and so
marked.
INSTRUCTIONS PERTAINING TO RISK
OF FIRE OR INJURY TO PERSONS
WARNING - TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS:
• Never look directly into the lighted lamp or shine the lamp into another person's eyes.
• Charge (use) only with originally supplied CLASS 2 transformer. Consult Manufacturer for replacement.
9:56 AM
Page 2
Total Length of Cord in Feet
26-50
51-100
101-150
(7,6-15,2m)
(15,2-30,4m)
(30,4-45,7m)
51-100
101-200
201-300
(30,4-60,9m)
(60,9-91,4m)
American Wire Gage
16
16
14
16
14
12
16
14
12
12
Not Recommended
2
• This LED Area Light is NOT waterproof. Do not submerge in liquids of any kind. Do not expose unit or charger to rain or wet
conditions. Water entering the light will increase the risk of electric shock.
• Do not drop or throw worklight. It contains a nickel metal hydride battery pack.
• Do not hang the LED Area Light on anything that could become electrically "live."
CHARGING SAFETY WARNINGS AND GUIDELINES
Before using battery charger, read all instructions and cautionary markings on battery charger and unit.
CAUTION: To reduce the risk of injury, charge only Black & Decker Batteries. Other types of batteries may burst causing
personal injury and damage.
• Do not expose charger to rain or snow. Use in a dry location only.
• Do not crush, cut, pull or expose charger cords to extreme heat.
• Position charger cords so they do not become entangled or become a safety hazard. Keep charger cords away from sharp edges.
• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting unit from the 120 Volt AC
Charger.
• An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of
fire, electric shock or electrocution.
WARNING: Use only the supplied charger when charging your tool. The use of any other charger could damage the tool
or create a hazardous condition.
• Use only one charger when charging.
• Do not attempt to charge the unit if the 120 Volt AC Charger plug is damaged— return the unit to manufacturer for repair.
WARNING: Do not attempt to open the charger. There are no customer serviceable parts inside. Return to manufacturer
for repair.
• A small leakage of liquid from the battery pack cells may occur under extreme usage, charging or temperature conditions. This
does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or vinegar.
c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate
medical attention. MEDICAL NOTE: The liquid is a 25-35% solution of potassium hydroxide.
• All ON/OFF switches should be in the OFF position when the unit is charging or not in use. Make sure all switches are in the
OFF position before connection to a power source or load.
• After charging/recharging, disconnect charger or extension cord and wait 5 minutes before use.
• Although this unit contains a non-spillable battery, it is recommended that unit be kept upright during storage and recharging.
To avoid possible damage that may shorten the unit's working life, protect it from direct sunlight, direct heat and/or moisture.
• IMPORTANT: This unit is delivered in a partially charged state. Fully charge unit for 24 hours before using for the first time
(refer to the "Charging/Recharging the Unit" section of this instruction manual).
• Read And Understand This Instruction Manual Before Using This Unit.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY:
Follow these instructions and review cautionary markings on product.
INTRODUCTION
Thank you for choosing the Black and Decker
®
Rechargeable High Output LED Area Light . Please read this guide carefully
before use to ensure optimum performance and avoid damage to the unit or items that you are using it with.
FEATURES
• Offers two lighting options: 13-LED Area light or 25-LED area light
• Cordless operation
• Built-in rechargeable Ni-MH battery (with supplied 120 Volt AC Charger)
• High impact, shatter-resistant ABS housing
• Innovative support cord supports light in nearly any orientation
OPERATING THE UNIT
Position the unit as desired. The ON/OFF Switch on the front of the unit has three positions.
The center position is OFF.
The right position turns 13 LED lights on.
The left position turns all 25 LEDs on.
CHARGING/RECHARGING THE UNIT
Insert the barrel connector of the AC Charger into the AC 5 Volt Charging Port on the side of the unit.
Insert the plug end into a (powered) standard North American 120 Volt 60Hz outlet. The red Charging
LED Indicator will light when the unit is charging.
Notes: Charge this unit ONLY with the originally supplied Class 2 transformer. Consult manufacturer
for replacement.
To extend battery life, disconnect the charger after 48 hours.
3
Advertisement
