Advertisement
Starting on corner A, take the lower cable and slide it into the
slot on the lower angle of the side frame bottom tube. Place (1)
5/16" x 1" carriage bolt in the slot to hold the cable in place.
Tighten 5/16" flange nut over the bolt to secure.
Repeat for the remaining 3 corners.
On corner D, insert the winch cable coming up out of the
spreader tube into the cable mount and secure with a washer
and 2 nuts.
On corners C and B, attach the cables
from the load tubes to the outer holes
in the cable mounting brackets with
washer and double nuts. Attach the
spreader tube cables to the inner holes
with washer and double nuts.
NOTE: all cables should be snug and
not too tight.
Advertisement
