CABINETS TO GO Findley & Myers BC12 Assembly Instructions
Base cabinet
Hide thumbs
Also See for Findley & Myers BC12:
- Assembly instructions manual (9 pages) ,
- Assembly instructions manual (8 pages)
Related Manuals for CABINETS TO GO Findley & Myers BC12
Summary of Contents for CABINETS TO GO Findley & Myers BC12
- Page 1 Base Cabinet ASSEMBLY INSTRUCTIONS These assembly instructions are only applicable for all one drawer Base Cabinets. ITEM #BC12, BC15, BC18, BC21, BC24, BC27, BC30, BC33 Page 1...
- Page 2 ► General Instructions: Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed to face the test of daily use and guaranteeing your enjoyment for many years to come. Carefully read the instructions before starting the installation. During assembly, please follow all generally accepted safety procedures. Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant damage and/or injury. Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist. Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will not be held responsible for failure to follow these instructions. PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE QUANTITIES MENTIONED BELOW.
- Page 3 Instructions: ► Place the face frame (A) face down on a flat soft working surface to ensure that the face is not scratched or damaged (Figure 1). Figure 1 Installing the Side Panels (Figure 2): Insert right and left side panels (B) into the grooves of the face frame (A) and align the cam lock connectors (Figure 2). Lock the cam with a screw driver by turning the screw 180° clockwise (Figure 4). Figure 4 Figure 2 Installing the Bottom (Figure 3): Gently spread the side panels and insert the bottom (C) into the grooves of side panels (B) until it is seated in the face frame (A). Align it and lock each cam. Figure 3 Installing the Back Panel and Toe Kick (Figure 5): ...
- Page 4 Install the D rawer Slide R ails: Insert the drawer side rail's back end (h) into the holder (g) previously installed (Step 4) on the back panel (D) (Figure 8). Then secure the drawer rail front end with 1/2” screws (e) using the pre‐drilled holes in the face frame (A). The remainder of the screws can be used to secure the drawer to the rails. 2 - 1 Set Top ...
-
Page 5: Maintenance
►Maintenance For daily cleaning, use a dry cloth and a soft liquid cleaner. Never use abrasive cleaners containing acetone, chlorine or strong bleach. Also, do not use tools as scrapers, metallic brushes, and other products which can scratch or tarnish surfaces. Under no circumstances should you use chrome cleaner on chrome-plated or brass tri m , hinges, handles, sockets etc.