Serialio Scanfob 2006 Quick Start Manual

Setting up Scanfob® 2006 in SPP mode for use with SerialMagic or SerialMagic Gears
To set up the Scanfob® 2006 for simulated keystroke injection with iOS or OSX see other side of sheet.

1. Charge

– Connect the Scanfob® 2006 to a powered USB port for about 4 hours, or until LED shows green. Only
charge the Scanfob® 2006 with approved charging devices. Use of non-approved charging devices can damage
the battery and void the warranty.

2. Install SerialMagic

– SerialMagic is available at serialio.com/products/SerialMagic/SmSuppPlat.php.
Download & install SerialMagic for your platform. Android users should visit the Google Play Store for
SerialMagic Gears.
3. Set Scanfob® 2006 to SPP mode

4. Make discoverable and connectable

to make the Scanfob® 2006 discoverable and connectable (LED will blink blue rapidly):

5. Launch SerialMagic/SerialMagic Gears

6. Connect

– Use SerialMagic to pair the Scanfob® 2006. Setup instructions for SerialMagic can be found at
www.serialio.com/support. The Scanfob® 2006's LED will blink blue slowly when connected. Android users
should use SerialMagic Gears. In Gears, tap "Connect" and a list of devices will pop up. Then tap "Scan for
devices" and select the desired scanner to pair.

7. Set SerialMagic scan behavior

Congratulations! The Scanfob® 2006 is now connected! For instructions on scanning into third party
applications, Android users should visit
Use the following barcodes to disconnect/reconnect your scanner:
_+-DISC-+_
Disconnect and Radio Off
You can also hold down the big button for 5 seconds to turn the Scanfob® 2006 off or on.
For complete Scanfob® 2006 documentation, visit
Quick Start Guide
For use with Android Mobile Device or Windows PC:
If using OSX with SerialMagic, configure device in SPP mode.
– Scan the following barcode to set the scanner's Bluetooth mode:
ÉÁSO?ËÍ
SerialMagic - SPP
– Scan the barcode below (or hold down the small button for 5 seconds)
_+-DSCO-+_
Make Discoverable & Connectable
– Scan the following barcode to set the correct scan behavior:
ÉÁRY1BRZ1MÇËÍ
Prefix=STX, Suffix=CR
serialio.com/support/SerialMagic/Android/SMKeys_Setup.php
Your serial solution provider on
over 500 mobile device models
_+-DSCO-+_
Reconnect SerialMagic
serialio.com/support
715 Discovery Blvd. Ste. 510
Cedar Park, TX 78613
Tel: (512) 994-3630
Fax: (866) 546-4523
For sales inquiries:
sales@serialio.com
For technical support:
support@serialio.com
1