Advertisement
Getting Started
Wire binding instructions
For use with Rexel 21 loop wire elements.
1
Set the wire
Lift the lid and punch handle to the upright position.
●
Place entire document so it rests on the lid.
●
Check the wire size (mm) needed using the paper thickness
●
guide.
Measure your wire using the wire size guide.
●
2
Sort paper
For managing large documents use the document separator.
●
Push the separator into the document.
●
Lift the separator upwards to reveal the first stack of paper ready
●
for easy punching.
3
Set paper size
Load the first paper stack into the punch slot.
●
Centre the paper using the dial located at the front of the
●
machine.
Adjusting your machine for A5:
Slide the switch located at the front of the machine from A4 to A5.
●
4
Punch paper
For manual punching: Lower the raised handle until the paper is
●
punched and support the machine when lifting the handle to the
upright position.
For electric punching (CWB406E only):
●
Press the 'punch button' located on the right panel of the
machine.
Note:
If the machine is overloaded and fails to complete the punch
cycle, the red LED will be lit. Press the 'punch button' to cancel
the red LED. If this does not work contact the service helpline.
5
Wire binding
Open the hinged cover at the front of the machine to reveal the
●
wire binding channel.
Place the wire (open side up) on the wire support.
●
Feed each paper stack onto the wire and repeat until your
●
document is complete.
Support the document and wire on removal from the wire support.
●
Insert the document into the wire closing jaws (wire opening face
●
down).
Support the document and pull down the handle at the side of the
●
machine to close the jaws.
Use the wire closing guide (located in the wire closing jaws) to
●
ensure correct closure of the wire.
Binding tips:
To hide the spine of the wire:
Load the internal sheets onto the wire first, repeating until all are
●
loaded.
Load the front PVC cover onto the wire element.
●
Load the rear cover onto the wire element last.
●
It is best to close the wire a little, check, and then close the wire a
●
little more until you are happy with the wire closure.
Always use the wire size closing guide (located in the wire closing
●
jaws) to prevent over closing the wire.
For further hints and tips please visit our website:
●
www.boundtopresent.com
6
Maintenance
Please ensure the clippings tray is emptied on a regular basis. This
may prevent your machine from overloading.
CWB406:
When the clippings tray is full, you will see the clear window full of
clippings. Empty the contents of the tray to continue binding.
CWB406E:
When the clippings tray is full, a yellow LED will be lit. Empty the
contents of the tray to continue binding.
3
Security
A security slot is fitted for use with leading makes of security leash.
E.g. Kensington Microsaver. (
)
Technical data
Technical data
CWB406
Operation mode
manual
Max. binding size
Hole pitch
US Pitch 9/6" / 14.28mm
Number of punch slots
Margin depth
Punching paper (80gsm)
Punching PVC plastic foils
(0.2mm)
Max. comb diameter (mm)
Max. wire diameter (mm)
Binding capacity (sheets)
Net weight (kg)
12.2
Dimensions WxDxH (mm)
525x450x200
Voltage
CWB406E is approved to EN60950 and CE Standards
Technical data subject to change without notification
GB
CWB406E
electric
A4
21
variable
max. 30
max. 4
50
14
450/140
17.1
525x450x170
230V 50Hz AC
Advertisement
