Change Advanced Settings - Philips HTS5580W User Manual

•
[Change Password] : Sets or changes
a PIN code to play a restricted disc.
Enter ' 0000 ' if you do not have a PIN
or if you have forgotten your PIN.
•
[Display Panel] : Changes the
brightness of the display panel.
•
[Auto Standby] : Enables or disables
auto standby. If enabled, the home
theater switches to standby after 30
minutes of inactivity (for example, in
pause or stop mode).
•
[VCD PBC] : Displays or skips the
content menu for VCD and SVCD
discs.
•
[Sleep Timer] : Sets a sleep timer to
switch the home theater to standby
after a speciÀ c time.
5
Press OK to conÀ rm your choice.
Note
• If your preferred disc language is not available,
you can select [Other] from the list and enter
the 4-digit language code which can be found
at the back of this manual.
•
If you select a language that is not available
on a disc, the home theater uses the default
language of the disc.

Change advanced settings

1
Press ( Home ).
2
Select [Setup] , then press OK .
3
Select [Advanced] , then press OK .
4
Select and adjust the following settings:
•
[BD-Live Security] : Restricts or allows
access to BD-Live.
• [Enhanced Audio] : Enables or disables
the audio post processing at the
speaker output.
• [Software Update] : Selects to update
software from the network or from
USB storage device.
•
[Clear memory] : Clears local memory,
delete the BD-Live À les that you
previously downloaded. If using an USB
storage device, the local storage folder
is 'BUDA'.
•
[DivX® VOD Code] : Displays the
DivX VOD registration code for the
home theater.
•
[Version Info.] : Displays the software
version for the home theater.
• [Restore default settings] : Resets the
home theater to the default settings
programmed at the factory.
5
Press OK to conÀ rm your choice.
Note
•
You cannot restrict internet access on
commercial Blu-ray discs.
•
Before you purchase DivX videos and play
them on the home theater, register the home
theater on www.divx.com using the DivX
VOD code.
• You cannot reset parental control setting to its
default value.
EN 23