Change Advanced Settings; Update Software; Check Software Version; Update Software From The Network - Philips HTS5220 User Manual

Change advanced settings

1
Press ( Home ).
2
Select [Setup] , then press OK .
3
Select [Advanced Setup] , then press OK .
4
Select and adjust the following settings:
•
[BD-Live Security] : Restricts or allows
access to BD-Live.
• [Enhanced Audio] : Enables or disables
the audio post processing at the
speaker output.
•
[Software Update] : Selects to update
software from the network or from
USB storage device.
•
[Clear memory] : Clears local memory,
delete the BD-Live À les that you
previously downloaded. If using an USB
storage device, the local storage folder
is 'BUDA'.
•
[DivX® VOD Code] : Displays the
DivX VOD registration code for the
home theater.
•
[Version Info.] : Displays the software
version for the home theater.
•
[Restore default settings] : Resets the
home theater to the default settings
programmed at the factory.
5
Press OK to conÀ rm your choice.
Note
• You cannot restrict internet access on
commercial Blu-ray discs.
•
Before you purchase DivX videos and play
them on the home theater, register the home
theater on www.divx.com using the DivX
VOD code.
•
You cannot reset parental control setting to its
default value.
20 EN
7

Update software

To check for new updates, compare the current
software version of your home theater with the
latest software version (if available) on the Philips
web site.

Check software version

1
Press ( Home ).
2
Select [Setup] , then press OK .
3
Select [Advanced Setup] > [Version Info.] ,
then press OK .
»
The software version is displayed.
Update software from the
network
1
Prepare the internet connection (see
'Connect to a computer network and the
Internet' on page 10 ) .
2
Press ( Home ) and select [Setup] .
3
Select [Advanced Setup] > [Software
Update] > [Network] .
»
If an upgrade media is detected, you are
prompted to start or cancel the update.
4
Follow the instruction on the TV to conÀ rm
the update.
»
When complete, the home theater
automatically switches off and on again.
•
If not, disconnect the power cord for a
few seconds and then reconnect it.
Note
• If the home theater is unable to connect to the
Philips server, press
> [Network Setup] > [Network Installation]
to set up the network.
( Home ), select [Setup]