Troubleshooting; Maintenance And Storage - Feider Machines FBVE3000 Instruction Manual

The motor does not run
The overload protection has responded

Set the reversing switch to position B and press the reset button, keep the on/off switch
pressed to switch on the shredder for a short period. After the blocking has been removed,
reset the reversing switch to position A.
Power failure

Check the power supply cord, the plug and your house connection fuse and RCD.
Safety switch on the collection box not locked in position

Ensure collection box is in position and locked.
The material to be chopped is not pulled in
The chopping knife is running backwards.

Change the direction of rotation.
The material is jammed in the feeding funnel

Set the reversing switch to position B and switch on the shredder. Pull the material from the
feeding funnel.
Re-feed thick branches such that the chopping knife does not immediately grasp the pre-
cut notches again.
The cutting blade is blocked

Set the reversing switch to position B and switch on the shredder The chopping knife will
now run backwards to release the blocked-up material.
Caution! Change the direction of rotation to the desired position after the shredder has
come to a complete standstill.
Take care of your machine and clean it regularly to obtain long-lasting efficiency and

performance.
Keep the air vents clean and free from dust.

Use only a warm damp cloth and a soft brush to clean your machine.

Never wet or spray water on the machine.

Do not use any detergents or solvents as these could cause irreparable damage to your

machine. Chemicals can destroy the plastic parts.
The tightness of the fastening screws of the undercarriage should be checked from time to

time.
To protect the shredder from corrosion when storing it for a longer period, treat the

chopping knife with some ecological oil.
When the machine is stopped for servicing, inspection, or storage, or to change any

accessories, shut off the motor, unplug the connection cable (to disconnect the electric
unit from the power supply), make sure that all moving parts have come to complete stop.
Allow the machine to cool down before making any inspections, adjustments, etc.
The shredded can be packed in the collection box for storage and transport. Follow below

steps:
a) Unlock the collection box by pushing the safety switch downwards. (Fig. 10-2)
b) Release the location plate by loosing the two screws. (Fig. 9)
c) Stand and put hands in position as shown in Fig. 12.
d) Push the motor unit horizontally to move protruding supports (Fig. 8/Item B) away from
slots (Fig. 8-2/Item A) of the base frame.

Troubleshooting

Maintenance and Storage