Table of Contents
Advertisement
not feature a safety mechanism to avoid
misfires. Do not point the tool towards
yourself or anyone whether it contains
nails/staples or not.
3.
Always assume the tool contains
fasteners.
4.
Do not point the tool toward yourself or
anyone whether it contains fasteners or
not.
5.
Do not actuate the tool unless the tool is
placed firmly against the workpiece.
6.
Respect the tool as a working implement.
7.
No horseplay. This tool is not a toy and
can be deadly if misused.
8.
Do not remove, tamper with, or otherwise
cause the tool operating controls to
become inoperable.
9.
Do not operate the tool if any portion of
the tool operating controls is inoperable,
disconnected, altered, or not working
properly.
10. Disconnect the tool from the air supply
when:
a. Unattended.
b. Performing any maintenance or repair.
c. Clearing a jam.
d. Moving the tool to a new location.
11. Do not make any modifications to this
tool.
12. Refer to the tool maintenance
instructions for detailed information on
the proper maintenance of the tool.
13. Fire fasteners into an appropriate
work surface only. Do not attempt to
fire fasteners into surfaces too hard to
penetrate. Do not drive fasteners on top
of other fasteners, or at too steep of an
SKU 97586
For technical questions, please call 1-800-444-3353.
angle. Fasteners can ricochet causing
personal injury.
14. Do not fire fasteners too close to the
edge of a workpiece. They may split the
workpiece and fly free, causing personal
injury.
15. Keep clear of the workpiece near the
area being fastened. Fasteners may
bend sideways during firing, causing
them to exit the workpiece at an
unexpected point, causing personal
injury.
16. Transport tool safely. Always disconnect
air supply when moving the tool. Carry
the tool by the handle and avoid contact
with the head cap.
17. Hold tool away from head and body.
During operation the tool may kick back
causing injury.
18. Do not fire fasteners into a workpiece
that has people, utility lines, or other
objects behind or inside it.
19. Keep balance while using this tool.
Keep area below clear if working in
an elevated location, and secure air
hose to prevent falls from bystanders
accidentally pulling on it.
20. Obey the manual for the air compressor
used to power this tool.
21. Install an in-line shutoff valve to allow
immediate control over the air supply
in an emergency, even if a hose is
ruptured.
22. Do not engrave or stamp anything into
the housing to prevent weakening of the
housing.
23. WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction activities,
contains chemicals known [to the State
Page 5
Advertisement
Table of Contents
