Sharp UX-370SE Service Manual page 9

3
Insert the stack of paper into the tray, print side down.
• If paper remains in the tray, take it out and combine it into a single
stack with the new paper before adding the new paper.
• Be sure to load the paper so that printing takes place on the print
side of the paper. Printing on the reverse side may result in poor
print quality.
4
Push the paper release plate back down.
• If the paper release plate is not pushed down, paper feed errors will
result.
Note: When receiving faxes or copying documents, do not allow a
large number of pages to accumulate in the output tray. This may
obstruct the outlet and cause paper jams.
5
Your fax has been set at the factory to print at normal contrast.
Depending on the type of paper you have loaded, you may find that
you obtain better print quality by changing the setting to LIGHT.
Press these keys:
FUNCTIOM
The display will show: PRINT CONTRAST
Press 1 to select NORMAL or 2 to select LIGHT.
NORMAL
1
The display will show: COPY CUT-OFF
Press the STOP key to return to the date and time display.
6
LIGHT
2
or
STOP
5. Clearing a jammed document
If the original document doesn't feed properly during transmission or
copying, or DOCUMENT JAMMED appears in the display, first try
pressing the START/MEMORY key. If it doesn't feed out, remove it as
follows:.
Important:
Do not try to remove a document without opening the operation panel.
This may damage the feeder mechanism.
1
Open the operation panel by grasping the finger hold and pulling up.
2
Remove the document.
3
Close the operation panel, making sure it clicks into place.
1 – 7
UX-370ES/SE/F
FO-780AT/ES
Clik!