Advertisement
INSTALLATION
Power
Antenna connections
The type plate is located on the rear of the unit.
AM antenna
The supplied loop antenna is for indoor use only.
1 Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
1 Fit the plug of the loop antenna to AM AERIAL as shown
not, consult your dealer or service organization.
2 Make sure all connections have been made before
2 Position the antenna as far as possible from a TV, VCR or
switching on the power supply.
3 Connect the supplied power cable to AC MAINS ~ and to
3 Turn the antenna for optimum reception.
the power outlet. This switches on the power supply.
For optimal performance use only the original power
cable.
When the unit is switched to standby, it is still consuming
some power. To disconnect the unit from the power
completely, remove the power cable from the power outlet.
FM antenna
The supplied wire antenna can only be used to receive nearby
To avoid overheating of the unit, a safety circuit has
stations. For better reception we recommend using a cable
been built in. Therefore, your unit may disconnect
antenna system or an outdoor antenna.
under extreme conditions. If this happens, switch the
unit off and let it cool down before reusing it.
1 Open the FM AERIAL 300 Ω click-fits by pushing the lever
Speaker connections
The speaker connections are click-fit connectors. Use them as
2 Insert each wire of the antenna into one hole.
shown below.
3 Close the click-fits using the lever.
4 Move the antenna in different positions for optimum
1 Connect the colored (or marked) wire to the red terminal
and the black (or unmarked) wire to the black terminal.
2 Connect:
– Left speaker to L (red and black)
– Right speaker to R (red and black)
The unit complies with the FCC-Rules, Part 15 and with
21 CFR 1040.10. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
8
below.
other radiation sources.
AM
AE RI AL
down as shown below.
reception.
L
FM AE RIA
L
FM AE RIA
Ω
Ω
300
300
including interference that may cause undesired
operation.
SUBWOOFER
AM
AERIAL
FM AERIAL
300 Ω
SUBWOOFER
OUT
DIGITAL
OUT
L
AUX
IN
R
DIGITAL
IN
L
LINE
OUT
R
TAPE RECORDER
CD PLAYER
Analog audio connections
Digital audio connections
AUX IN L/R
DIGITAL IN
It is possible to use an additional appliance, e.g. tape
You can use this coaxial input for recordings from any digital
recorder, TV or VCR, with the unit.
audio equipment with a digital coaxial output e.g. CD player
or DVD player.
1 Insert the red plug of a cinch cable to the red jack AUX IN R
and insert the white plug to the white jack AUX IN L.
1 Use a coaxial cable to connect the coaxial output of the
2 Connect the other end of the cinch cable to the audio
outputs of the additional appliance.
2 Press DIGITAL / ANALOG AUX repeatedly to select the
3 Press DIGITAL / ANALOG AUX repeatedly to select the
analog input for the appliance.
y
AUX Analog is displayed.
3 Operate your appliance as usual.
4 Operate your appliance as usual and adjust volume and
DIGITAL OUT
sound with the unit.
You can use this coaxial output for recordings on any digital
audio equipment with a digital coaxial input e.g. CD recorder.
Note: It is not possible to connect a turntable directly to
AUX IN L/R. If you wish to use a turntable with the
• Use a coaxial cable to connect the coaxial input of the
unit, you have to connect an amplifier to AUX IN L/R on
the unit. Then connect the turntable to the amplifier.
LINE OUT L/R
Connecting a subwoofer
You can use these outputs for playback or recording on any
A subwoofer can be used to enhance the bass performance of
analog audio equipment e.g. amplifier or tape recorder.
your unit dramatically.
• Use a cinch cable to connect the analog audio inputs of the
1 Use a cinch cable to connect the input of the subwoofer
additional appliance with LINE OUT L/R on the unit and
operate your appliance as usual.
2 Follow the instructions supplied with the subwoofer.
INSTALLATION
SPEAKERS 6 Ω
L
R
~
AC MAINS
CD RECORDER
additional appliance with DIGITAL IN on the unit.
digital input for the appliance.
AUX Digital is displayed.
y
additional appliance with DIGITAL OUT on the unit and
operate your appliance as usual.
with SUBWOOFER OUT at the unit.
9
Advertisement
