Table of Contents
Advertisement
(2) Verify settings for LG Term program.Check setting of LG
Term program.
Sellect the 'Setup' on upper Menu. -> Sellect the 'Serial
Port'. -> Set to Port : COM1, Baud rate : 115200.
(3) If operates pressing Enter key, it means that it is
connected normally.
(4) Menu.Press d key and than Enter key to enter a Debug
Main Menu.
<Fig. 10>
(5) If you want to enter a Micom Download to download
MICOM program file, input 0xf1, and if you want to finish
Menu, input 0xff.
<Fig. 11>
<Fig.9>
(6) If you want to download MICOM program after select 0x1
in MICOM Download Menu, press 1 key, and if you want to
get out of the Menu, press any key.
(7) If you press 1 key, appears the massage to select MICOM
program file to download. And than select File -> Send file
in Menu, and select MICOM program file (*.hex) to
download.
(8) If appears the massage 'Micom Init End', the download is
done succesfully.
7. EDID(HDMI) Data Input
7-1. Required Test Equipment
(1) Equipment for EDID download(Dual USB to 12C)
(4) S/W for DID download(EDID Tester)
7-2. Adjustment Preparation and Setting of
Device
<Fig. 13> Device Setting Diagram for EDID Memory download
(1) Setup as in <Fig. 13> and turn on the PC & JIG.
(2) Operate the S/W for EDID download(EDID Tester)
7-3. Sequence of Adjustment
(1) Put the SET(or Digital Board) on the table and turn the
power on.
Connect the JIG for download to HDMI port.
(2) Open the first file DVI file for Port.
(3) Select the Digital in "Data or Target connceting check"
item of S/W menu.
(4) Perform EDID Write command with Function key F8.
(5) OK will be seen once the download is complete.
* If you turn on the power source, must use POWER-Only with
adjustment remote-control.
When the unit powers on, use the Power Only button on the
service remote to access the EDID mode.
- 13 -
<Fig. 12>
DLP PJTV SET
(or digital board)
PC
JIG
Advertisement
Table of Contents
