Advertisement
Using the QT3-1 Tag
This section covers how to use the Quuppa QT3-1. Please note that the Quuppa QT3-1 is compatible with
Quuppa system release 8.0 or above.
General Instructions
Activating the QT3-1
Before using the Quuppa QT3-1 you must activate it and configure it for your Quuppa system. To activate the
tag, use the Button Press method, i.e. press the button for 1 second to activate the Quuppa QT3-1.
With the default configurations set for new QT3-1 tags, the tag will remain activated for 24 seconds after it
becomes inactive before entering the storage mode again.
Configuring the QT3-1
Tag configurations define the behaviour of the tags in your Quuppa system. For example, you can configure
a tag to blink its LED light every time it enters a particular zone within your Quuppa system.
Note: The LED blink uses a relatively large amount of power and so we recommend that to conserve
the tag's battery, you only use the LED blink when necessary.
New tags will be configured to use a default configuration. You can change this configuration to better suit
the needs of your use case.
To apply a new configuration, make sure that the tag is activated and use one of the following methods to
send the new configuration to the tag:
• Quuppa Site Planner (QSP) and a Focusing Locator
• Quuppa Positioning Engine (QPE) API requests
For more information, please refer to our product documentation available at quuppa.com/documentation.
Attaching QT3-1 to a Locatable Object
Attach the Quuppa QT3-1 to a locatable object.
Important: For optimal operation do not attach Quuppa QT3-1 onto a large metallic surface.
Warning: Never attach Quuppa QT3-1 onto hot surfaces.
QT3-1 Tag User Manual
© 2020-2022 Quuppa Oy. All rights reserved. The content provided is subject to change without notice. For the latest version,
go to quuppa.com/documentation. Updated: 06.09.2022 | Release: DRAFT | Type: Highly Confidential
5
Advertisement
