Trademark And Legal Notices - BeaverLAB DDL-M2 Instruction Manual

The product cannot be turned off
or the button does not work
Screen black screen does not
display, flashing screen, etc.
Memory card cannot be read
Note: It is normal for the APP to exit after plugging

9 Trademark And Legal Notices

"BeaverLAB" is a trademark applied for or registered in mainland China by Beaver Technology (Shenzhen) Co., Ltd.
and is used on this merchandise. Without the permission of the trademark owner, no person or organization may
use the above trademark mark on goods that are not approved.
This manual is produced and copyrighted by Beaver Technology (Shenzhen) Co., Ltd. and may not be reproduced or
distributed in whole or in any part by any organization or individual without permission.
Due to the continuous improvement of product functions, design changes and other reasons, this manual may not
match the product you purchased, please refer to the actual product.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Crash
Malfunction, damage
Bad contact or damaged memory card
Perform a reset operation
①Check if it works properly after resetting
②Check if the memory card is working
properly after inserting and removing it
③Send for repair
①Re-plug the memory card
②Replace the memory card with a new one
24