Accessories - Husqvarna T540XP Mark III Operator's Manual

Saw chain speed at 133% of maximum engine power
speed, m/s.
Recommended cutting equipment
Chainsaw models Husqvarna T540XP
have been evaluated for safety according to EN
ISO 11681-2:2011 (Machinery for forestry - Portable
chainsaws - Safety requirements and testing. Part
2: Chainsaws for tree service) and fulfill the safety
requirements when equipped with the below listed guide
bar and saw chain combinations.
Kickback and guide bar nose radius
Guide bar
Length, in/cm Pitch, in
12/30
14/36 0.325 mini
16/41
The usable cutting length is usually 1 in less than the
nominal guide bar length.
Filing equipment and filing angles
Use a Husqvarna file gauge to sharpen the saw chain.
A Husqvarna file gauge makes sure that you get the
5/32 in /
SP21G
4.0 mm
200

Accessories

®
Mark III
Gauge, in/mm
0.043/1.1
0.025 in /
595 00 47-01
0.65 mm
Husqvarna T540XP
26.9
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Saw chain
Max. nose ra- Type
dius
Husqvarna
8T
SP21G
correct filing angles. The part numbers are given in the
table below.
If you are not sure how to identify the type of saw chain
on your product, refer to www.husqvarna.com for more
information.
30°
®
Mark III
Length, drive
links (no.)
51
59
64
60° 0°
1792 - 005 - 02.11.2022
Low kickback
Yes
595 00 46-01