Federal Communications Commission (FCC) and Industry Canada (IC) Information:
This device complies with part 15 of the FCC Rules and Regulations and RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation. In Canada, users should be cautioned to take
note that high power radars are allocated as primary users (meaning they have priority) of 5250 –
5350 MHz and 5650 – 5850 MHz and these radars could cause interference and/or damage to
license-exempt local area networks (LELAN).
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and RSS-210 of Industry Canada. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used
in accordance with these instructions, may cause harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment on and off, the user is encouraged to correct the interference
by one or more of the following measures:
•
Increase the separation between the affected equipment and the unit;
•
Connect the affected equipment to a power outlet on a different circuit from that which the
receiver is connected to;
•
Consult the dealer and/or experienced radio/TV technician for help.
FCC ID: ABZ89FC3789
FCC ID: ABZ89FC4816
The term "IC:" before the radio certification number only signifies that Industry Canada
technical specifications were met.
Important Note:
Intentional or unintentional changes or modifications must not be made unless under the express
consent of the party responsible for compliance. Any such modifications could void the user's
authority to operate the equipment and will void the manufacturer's warranty.
Subscriber Module (SM) must be installed to provide a separation distance of at least 20 cm (7.9
in) from all persons, when adding the Canopy reflector dish (in the 5.7 GHz band), the reflector dish
must be installed to provide a separation distance of at least 1.5m (59.1 in) from all persons and
does not emit a RF field in excess of Health Canada limits for the general population; consult
Safety Code 6, obtainable from Health Canada's website http://www.hc-sc.gc.ca/rpb. Furthermore,
it must not be co-located or operating in conjunction with any other antenna or transmitter.
MOTOROLA, the stylized M Logo and all other trademarks indicated as such herein are
trademarks of Motorola, Inc. ® Reg. U.S. Pat & Tm. Office. Canopy is a trademark of Motorola,
Inc. All other product or service names are the property of their respective owners.
Motorola, Inc
Broadband Wireless Technology Center
50 East Commerce Drive
Schaumburg, IL 60173
http://www.motorola.com/canopy
NOTICES
IC: 109W-5200
IC: 109W-5700
Page 2
The Canopy