Home Page; Status Page - Motorola Canopy Subscriber Module User Manual

Table of Contents

Advertisement

WEB PAGE INFORMATION
Web pages are available for each Canopy unit. These pages are used to configure the unit and to
evaluate its performance. Access the web pages by entering the IP address for a Canopy product
into a standard web browser. Descriptions of these pages are provided on the following pages.
Home
Status
Configuration
Alignment
Event Log
AP Eval Data
Link Test
Packet Status
The default page, when accessing the IP address of the Canopy unit is, the Status page.

HOME PAGE

The Home page contains a welcome message for the product. There are no configurable items on
this page.

STATUS PAGE

The Status page contains information on the operation of the product. It is the default webpage.
The following parameters are displayed.
Parameter
Device type
Software version
FPGA version
Device ESN
Uptime
System time
Session status
Data slots up
Data slots down
Air delay
RSSI
Jitter
Ethernet interface
Description
The parameter should display Subscriber Modem – Multipoint
Mode. Describes the configuration the unit has been set to.
Displays the version of software currently loaded into the unit.
Displays the version of the FPGA (field programmable gate array)
currently loaded into the unit.
Displays the Electronic Serial Number of the unit.
This parameter displays the length of time the unit has been
operating since power was applied.
This parameter is set by the access point at registration.
This parameter displays 1 of 4 states when the unit is in operational
mode. Scanning, Syncing, Registering, and Registered are the four
states.
This information is used only by the Canopy team.
This information is used only by the Canopy team.
Displays the distance from the subscriber module to the access point.
Displays the Radio Signal Strength Indicator.
Displays the quality of the RF signal. The scale is from 5 to 15, where
5 is the best quality.
Displays the configuration of the Ethernet Interface. The interface
can be either 10 or 100 baseT and either half or full duplex.
Page 10

Advertisement

Table of Contents
loading

Table of Contents