Table of Contents
Advertisement
process until you have your desired projection size. At the maximum beam size, the primary and
secondary optics will be touching each other at about 1/4
of the length of the optic slider rails.
th
When you have the beam adjusted to the focal setting you would like, tighten down the set screws on
the primary and secondary optics. Complete the adjustment by screwing the barrel back onto the
fixture.
INSTALLING ACCESSORIES
A removable cutaway snoot for shielding the light source from view is available for the Storm Form.
Installing the snoot: The snoot can be adjusted or removed by loosening the three set screws that are
located toward the back of the snoot. You can then rotate the snoot to the appropriate position, and
finally tighten down all three set screws.
Storm Form and Storm Form DMX User Guide
Version 1.1 – 2/25/2021
Advertisement
Table of Contents
