Mounting Instructions - Gantom STORM FORM User Manual

Safety and Operation notes:
Please carefully review the following safety notes regarding the Storm Form micro gobo projector. These
notes are important for safe installation and usage of the product.

Do not look directly at the light source while the fixture is powered on.

Inspect all power cables for damage or crimped cable before use.

Make sure that your circuit is properly grounded and all electrical safety precautions have been
taken to prevent electric shock.

Be aware that the fixture will become HOT to the touch when it is left on.

Allow several minutes for the light to cool before touching it after extended periods of on time.

Ensure that there are no flammable materials close to or in contact with the light fixture.

Never touch the lenses within the fixtures. If the lenses must be cleaned, use a microfiber cloth
and glasses cleaning solution.

Make sure that the locking cable connectors are fully tightened when the product is installed.

Check the voltage of the power line before connecting the fixture to ensure that it is within the
required range for the fixture.

In the event of a serious operating problem, cut power to the fixture and cease operation
immediately.

For technical support, please contact
426-8661).
The Storm Form micro gobo projector comes with an aluminum mounting yoke pre-installed. It is meant
to be used with ¼" size hardware, but please note that mounting hardware is not included with the
fixture. The yoke has a hole and a curved slot. Install a screw in the center hole first, then loosely screw
down a second screw through the curved slot. Rotate the fixture to the appropriate angle and then
finally tighten down both screws all the way to lock the fixture in place.
Support@GANTOM.com

MOUNTING INSTRUCTIONS

Storm Form and Storm Form DMX User Guide
or call 1-855-GANTOM1 (1-855-
Version 1.1 – 2/25/2021