Cleaning; Disposing Of Waste - Toro 75304 Operator's Manual

3. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
4. Install the spring onto the straight end of the rod.
5. Position the spring on the rod as shown in
67 so that the shorter spring end comes from
under the rod before the bend and going over
the rod as it returns from the bend.
6. Lift the loop end of the spring and place it into
the notch on the deflector bracket
Figure 67
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
7. Secure the rod and spring assembly by twisting
it so that the short end of the rod is behind the
front bracket welded to the deck
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
Figure 67.
Figure
(Figure 67).
g297573
3. Rod, short end, moved
behind the mower bracket
4. Short end, retained by
mower bracket.
(Figure 67).

Cleaning

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
46