Little Giant 6 Series Owner's Manual page 4

PRODUCT DESCRIPTION
Models
PRODUCT DESCRIPTION
This submersible pump is for use in basins or lift stations and is suitable for pumping clear water. Do not use
the pump in applications where effluent (gray water), sewage, or any other debris (gravel, sand, floating
debris, etc.), abrasives, or corrosives are present. The pump comes with a 1½-inch female pipe thread dis-
charge and a 1¼-inch FNPT reducing bushing. Sump pumps can be piped to discharge into the house drain-
age system, to a dry well, splash block, or to a storm drain, depending on local plumbing codes. Both
automatic and manual versions of these pumps are available.
The pump motor is equipped with an automatic resetting thermal protector, and may restart unexpectedly.
Thermal Protector tripping is an indication of motor overloading or overheating, which can be caused by
application issues such as an obstructed pump impeller, switch stuck in the ON position, pump running dry,
pump air-locked, pump short cycling, excessively high or low voltage supply, or possibly a pump, motor,
bearings, or seal that have reached the end of their useful life.
This product is covered by a Limited Warranty for a period of 3 years from the date of original purchase by
the consumer. For complete warranty information, refer to www.LittleGiant.com; or call Customer Support
for a printed copy.
Models
Model
6-CIA Automatic with diaphragm switch
6-CIM
6-CIM-R
6-CIM-RS Automatic with remote diaphragm switch
6-CIA-RFS Automatic with remote float switch
6-CIA-ML
Automatic with diaphragm switch
6-CBA
6-CBM
* Pumps are not dual voltage.
Manual pumps can be converted to Automatic mode by installing a separate liquid level control, such as an
RS-5 Remote Switch kit.
Flow Rates
Gallons/Liters per Minute at height
5 ft (1.5 m)
46 / 174
4
Pump Activation Method
Manual
Manual
10 ft (3 m) 15 ft (4.5 m)
29 / 110 12.5 / 47.3
HP PSI Voltage
115 or
230*
⅓ 7.8
115
Shut Off
18 ft (5.5 m)
Amps
15 or
10
15