Combining Parameters For Signal Generation; Instrument Modes - Keysight Technologies 15433B User Manual

Using the Keysight 81133A/81134A Pulse Generator
Instrument Mode
Pattern Mode
Signal Mode
Variable
Crossover
Burst Length
Factor p
(For calculating the
length of the pause
that follows the
repeated data)
70
Combining Parameters for Signal
Generation
The following table shows you how the various modes and
parameters can be combined. Empty cells indicate that the
combination is not applicable:
Pulse/Pattern
Square Pulse
R1
NO TE For the clock source, the Internal YIG Oscillator, External Clock
Input and 10 MHz Reference can be used as the clock source for
all combinations. The Internal Direct and External Direct can only
be used as the clock source for Square pattern mode and NRZ
signal mode.

Instrument Modes

The instrument provides the following modes:
• Pulse/Pattern Mode
In this mode, each channel can be set independently to generate
a continuous stream of:
– Square waves (clocks) of fixed width
– Pulses with selectable width or duty cycle

Combining Parameters for Signal Generation

Data/PRBS
RZ NRZ R1
30%
...
70%
1 ... 16384
Keysight 81133A/81134A Pulse Generator User's Guide, April 2015
Burst RBurst
Data Data
RZ NRZ R1 RZ
30%
...
70%
4 ... 16384
(in increments of 4)
4 ... 16384
(in increments of 4)
NRZ
30%
...
70%