Table of Contents
Advertisement
• First, use the ASM (Automatic Search Memory) function to preset all the active channels in your
area automatically.
Then, arrange the preset channels with the SEARCH (>>>), MFT (Manual Fine Tuning) and
AFT (Auto Fine Tuning) functions so that you can tune into only desired channels.
• This section shows how to tune in channels using mainly the Remote Controller. You can also
perform the system select, ASM, SEARCH (>>>), SKIP, MFT and AFT operations using the
buttons on the TV set.
To preset channels (ASM)
ASM (Automatic Search Memory)
1
Select the head of the position number to start the
ASM with the position down ( )/up ( ) buttons or the
digit/direct select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Confirm that "COLOR" is set to "AUTO" and "SOUND"
is set to proper system.
If not, press the t/s buttons to move the cursor (-) to
"COLOR" or "SOUND" and press the
select each proper system.
4
Press the t/s buttons to move the cursor (-) to
"ASM".
5
"+"
Press the
button to start the ASM. All active
channels will be preset automatically.
When presetting is complete, the initial position number
will reappear.
After presetting
Check the preset channels by pressing the position down
(
)/up (
) buttons.
• If the picture or sound of a certain channel is not good, fine-
tune the channel using the MFT function.
• If the colour of a certain channel is abnormal, automatic
colour system selection (AUTO) may malfunction, or sound
system selection is wrong. In such a case, select another
colour and/or sound system.
PROGRAMMING CHANNEL MEMORY
–
+
/
buttons to
– 16 –
To preset channels
(Manual search, AFT, MFT)
Manual search (>>>)
1
Select a position number with the position down ( )/
up (
) or digit/direct select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Press the t/s buttons to move the cursor (-) to ">>>".
–
+
4
Press the
/
buttons to start searching.
–
The
button searches for lower-numbered channels;
+
the
button for higher- numbered channels.
Repeat this process until you can get the desired channel.
5
When the desired programme is shown, press the t/s
buttons to move the cursor (-) to "
+
6
Press the
button to memorize the channel at the
current postion.
7
When you desire to store another channel at another
postion, move the cursor (-) to "POSITION" with the t/
s buttons and select a desired position with the
buttons.
Then, press the t/s buttons to move the cursor (-)
to ">>>" and repeat the steps 4 to 7.
* Please refer to owners manual in details.
".
–
+
/
Advertisement
Table of Contents
