Table of Contents
Advertisement
• Use the SEARCH function if desired channels could not be preset with the ASM, or if you would
like to preset the desired channels to specific position numbers one by one.
• The adjustments below are not necessary under normal conditions. However, in areas of
inferior broadcast conditions where adjustment is necessary for a better picutre, adjust the
tuning with the MFT (Manual Fine Tuning). The AFT OFF status automatically keeps the
condition adjusted with the MFT function.
• The AFT (Auto Fine Tuning) function automatically corrects slight fluctuations when receiving
signals.
• When using Manual Search to preset the channel, the AFT will automatically turn ON and SKIP
to OFF.
MFT (Manual Fine Tuning)
1
Select the position number you want to fine-tune with
the position down (
)/up(
select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Press the t/s buttons to move the cursor (S) to
"MFT".
4
Press the –/+ buttons until the best possible picture
and sound are obtained.
Note
When operating the MFT function, the AFT status is
automatically set to OFF.
AFT (Auto Fine Tuning)
1
Select the position number you want to fine-tune with
the position down (
)/up(
select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Press the t/s buttons to move the cursor (S) to
"AFT". Press the –/+ buttons to select the "ON"
indication.
Note
When position is set to AFT OFF status, the "R" mark
appears to the left of the position number.
When the channel is set to AFT ON status, the
position number is displayed without the "R" mark.
) buttons or digit/direct
) buttons or digit/direct
– 17 –
To skip unnecessary position numbers
After presetting the channels, you may skip unnecessary
position numbers so that only the channels you want to
watch are selected.
To skip a position number
1
Select the position number to be skipped with the
position down (
)/up (
select buttons.
2
Press the MENU button repeatedly to call up the SET
UP menu on the screen.
3
Press the t/s buttons to move the cursor (S) to
"SKIP".
4
Press the –/+ buttons to select "SKIP ON".
5
Press the MENU button to turn off the SET UP menu
display.
Select the position number to be skipped with the direct
select buttons. The * mark appears to the left of the
position number.
The position number will then be skipped when you
select channels with the position down (
buttons.
To restore a skipped position number
1 Select the position number you want to restore with the
direct select (and/or digit select) buttons.
2 Press the MENU button to call up the SET UP menu
display and press the t/s buttons to move the cursor (S)
to "SKIP".
3 Press the –/+ buttons to select "SKIP OFF".
* Please refer to owners manual in details.
) buttons or digit/direct
)/up (
)
Advertisement
Table of Contents
