Advertisement
Install instructions for CI rectangular flush mounts models:
C I - S U R R
T E C H N O L O G Y
Fig. 1a
Stereo Point Source
– 8 ohms -
Use this configuration to combine left
and right channels for full fidelity
sound from a single loudspeaker
stereo source. (Fig. 2a) Set jumper
plugs in the stereo position. Connect
right and left signal wires to the
spring-loaded terminals on the rear of
the speaker. Leave the front panel
switch in the Bi-Pole position.
Fig. 2a
5.
Use the provided tool to fully open the Quick
Mount Clamps (QM). If the tool is not available,
a small screw driver can be used.
(Fig. 3a)
8.
Using some familiar source material, listen
to the tweeter's balance with the level control
in each of its three positions to find your
favorite.
6400 Youngerman Circle | Jacksonville, FL 32244 | (888)phase tk | www.phasetech.com
3.
Remove the grille from the mounting flange by
pressing it from behind. Attach the provided white
gasket material to the outside, rear edge of the
flange. Insert the mounting flange into the hole with
the end marked "TOP" facing up. Loosen the flange
clamping screws one turn (counter clockwise) to
release the clamp. Next tighten all 4 flange clamp
screws evenly to secure the flange to the wall. It is
best to tighten each screw with the same amount of
force (torque). (Fig. 1b)
CAUTION: Do not over tighten.
Stereo
– 8 ohms – Use this configu-
ration to drive one channel (left or
right) of a stereo pair. Set jumper
plugs in the stereo position. (Fig. 2a)
Connect the right or left signal wire to
the right set of terminals on the rear
of the speaker. Leave the front panel
switch in the Bi-Pole position.
MONO
STEREO
Fig. 2b
6.
Insert the baffle into the mounting flange,
aligning QM clamps with the four QM posts. Also
make sure that the tweeter is placed at the end of
the flange marked
Fig. 3a
Fig. 1b
Mono/Stereo
– 4 ohms – Use this
configuration to drive one channel (left or
right) of a stereo pair with a 4 ohm speaker
load. Set jumper plugs in the mono
position. (Fig. 2b) Connect the right or left
signal wire to the left set of posts on the
rear of the speaker. Acoustic output of the
speaker is increased by 3 dB in this
configuration. Leave the front panel switch
in the Bi-Pole position
MONO
STEREO
"TOP".
Fig. 3b
Speaker Installation:
4.
Select the desired configuration for your
CI-Surround speaker as listed below. Connect speaker
wires to spring-loaded input terminals on rear of
speaker, making sure no loose strands are exposed.
-
+
red/positive
black/negative
flange screw
Bi-pole/Di-pole
– 4 ohms – Use this
configuration for home theater surround
applications. For Bi-pole mode, connect
as in the Mono/Stereo instructions: one
speaker to each surround channel and
set the front panel switch to the
position. For Di-Pole mode simply move
the front panel switch to the Di-Pole
position. (Fig. 2c)
Fig. 2c
7.
Tighten down the four QM clamps by pressing them
down flush with the baffle's surface. (Fig. 3b)
9.
Carefully install grille by pressing it into the gap
between the flange and the baffle and enjoy your
new Phase Technology CI speakers. (Fig. 4)
Bi-Pole
Fig. 4
Advertisement
