Motor Housing; Tube And Bell; Blade; Aluminum - Robot Coupe MP 350 Turbo Operator's Manual

• MOTOR HOUSING

The Immersion Blender must be clean through all
stages of production. Clean between each job using
a detergent or disinfectant. Dilute the detergent/
disinfectant following the instructions normally
specified on it's packaging container. Use a cloth
lightly dampened (not dripping) with the cleaning
solution.
Do not allow liquid to come into contact with
the electrical components contained within
the housing. Be careful when cleaning around
vents do not allow liquid to drip or seep into
the housing. Use a cloth lightly dampened (not
dripping) with water to remove detergent/
disinfectant then dry using a clean cloth.
After using the Immersion Blender in a hot mixture,
cool the bottom of the tube in cold water before
disassembling the bell from the tube.
Clean immediately after use to prevent product from
sticking to surfaces.
W A R N I N G
Never immerse motor housing and/or handle
in liquid! The housing contains the electrical
components and is not sealed against liquid.
Contact with liquid can cause damage to the
Immersion Blender and serious injury to the
operator.

• TUBE AND BELL

There are two ways to proceed:
• Simple cleaning procedure after each different
use
- Submerge the tube and bell in water and run for a
few seconds to clean.
- Unplug the power cord.
Complete cleaning procedure on a daily basis
- Unplug the Immersion Blender and rinse the bell
under a water tap.
- Remove the bell from the tube, then remove the
blade (wear cutting gloves) ! Be careful to avoid
damaging the surface of the blade shaft and the
watertight seals.
- Always dilute the detergent/disinfectant (see
above).
- Thoroughly dry all parts before reassembling.

• BLADE

The blade can be removed from the bell for
thorough cleaning.
After cleaning, dry all the parts carefully to prevent
oxidation.

• ALUMINUM

Use soft-metal-safe cleaning agents!

• PLASTIC

Be careful, many cleaning agents are corrosive and
are not safe for use on plastics!
Do not use strong alkaline detergent (having a high
concentration of soda or ammonia).

• WHISK GEARBOX

Never immerse the whisk gearbox in water. Clean
it with a cloth lightly dampened (not dripping).
Never run the whisk gearbox through a
dishwasher.

• WHISKS

The whisks can be cleaned either by hand or in a
dishwasher.
To ensure effective cleaning, always remove the
whisk ejector.

• MIXING TOOL HOUSING

Never immerse the mixing tool housing
in water or put it in the dishwasher.
Instead, clean it with a slightly damp
cloth.

• MIXING TOOL

The mixing tool can be washed either
by hand or in the dishwasher. You can
also clean it with a slightly damp cloth.

MAINTENANCE

• BLADE
The performance of the cut essentially depends
on the state of your blades and their wear. The
blades are subject to wear and as such need to be
replaced from time to time to ensure the consistent
quality of the end product.
You are also advised to change, at the same time,
the washer and the watertight seals.
A blade service kit is available.
• WHISKS
The performance of the whisks depends on the
condition of the wires. The metal wires may become
worn over time. In order to ensure optimum
performance, they will need to be replaced. Do not
use a defective or damaged whisk!
11
03/11/2022