MD310, MD390, MD450
7
Installing safe
7.1
Notes on installation
A
NOTICE!
The safe must only be installed by qualified specialists.
Follow the instructions when installing.
•
Carefully check the safe for damage once you have removed it from the
packaging. If there is visible damage, contact the manufacturer (see rear of safe
for addresses).
•
Install the safe on a flat and even surface.
•
Select a location for installation which is a sufficient distance from heat sources
(e.g. radiators). Avoid installing in locations with temperatures of under 0 °C and
over 45 °C.
•
Avoid damp ambient conditions (e.g in the bathroom and swimming pool) in
order to avoid condensation forming in the device.
•
Select a fastening material (screws with plugs, if necessary) which is appropriate
for the base.
7.2
Attaching the safe
➤ Select a suitable installation location.
➤ Select an appropriate method for installation (attachment on the rear or on the
underside).
➤ Mark the drill holes according to the table below
Drilling on the rear (fig. 2, page 2)
Model
H
L1
L2
EN
MD450
100 mm
120 mm
210 mm
MD390
100 mm
90 mm
210 mm
Installing safe
MD310
82.5 mm
50 mm
210 mm
7