Table of Contents
Advertisement
6.4
Intel
enterprise Utility (Windows)
The Intel
®
Rapid Storage Technology enterprise utility allows you to create RAID 0,
RAID 1, RAID 10 (RAID 1+0), and RAID 5 set(s) from Serial ATA hard disk drives
that are connected to the Serial ATA connectors supported by the Southbridge.
Before you using Intel
change BIOS setting first:
1.
Enter the BIOS Setup during POST.
Go to the Advanced Menu > Chipset Configuration > PCH Configuration
2.
> Onboard SAS Oprom, then press <Enter>.
Set Onboard SAS Oprom to [Enabled].
3.
4.
Press <F10> to save your changes and exit the BIOS Setup.
You need to manually install the Intel
utility on a Windows
instructions in Chapter 6.
To enter the Intel
operating system:
1.
Turn on the system to windows desktop.
Click the Intel
2.
main menu.
Your storage system is configured for data protection, increased performance and
optimal data storage capacity. You can further optimize your storage system by
creating additional volumes.
You can click Rescan to re-scan any attached hard disks.
6-34
®
Rapid Storage Technology
®
Rapid Storage Technology enterprise utility, you need to
operating system. Please refer to the installation
®
®
Rapid Storage Technology enterprise utility under Windows
Rapid Storage Technology enterprise icon to display the
®
®
Rapid Storage Technology enterprise
Chapter 6: RAID configuration
Advertisement
Table of Contents
