Elastic Zigzag Stitches; Cord Guide Bobbin Cover (Using A Zigzag Stitch); Tape Attaching - Baby Lock Destiny II Manual

■ Cord Guide Bobbin Cover (Using a
Zigzag Stitch)
a
Remove the bobbin cover from the machine
(see page 57).
b
Thread the gimp thread through the hole in
the cord guide bobbin cover from top to
bottom. Position the thread in the notch at
the back of the cord guide bobbin cover.
a Notch
b Gimp thread
c
Snap the cord guide bobbin cover into
place, making sure that the gimp thread can
be fed freely.
* Make sure there are no restrictions when feeding the
thread.
d
Set the zigzag width from 2.0-2.5 mm
(approx. 1/16 - 3/32 inch).
e
Attach presser foot "N".
f
Position the fabric right side up on top of
the cord and place the cord to the rear of
the machine under the presser foot.
a Fabric (right side)
b Gimp thread
g
Lower the presser foot and start sewing to
make a decorative finish.

Elastic Zigzag Stitches

Use elastic zigzag stitches for tape attaching,
overcasting, darning, or a wide variety of other
uses.
Stitch Stitch name
2 steps elastic zigzag
2 steps elastic zigzag
3 steps elastic zigzag
a
Select a stitch.
b
Attach presser foot "J".

■ Tape Attaching

While stretching the tape flat, sew it to the fabric.
a Tape
SEWING THE STITCHES
Presser foot
3
123