Table of Contents
Advertisement
Installation
Initial Inspection
Initial Inspection
Inspect the shipping container for damage. If the shipping container or
packaging material is damaged, it should be kept until the contents of
the shipment have been checked mechanically and electrically. If there
is mechanical damage notify the nearest Agilent Technologies office as
shown in
any) for inspection by the carrier and an Agilent Technologies
representative.
Operating Precautions
NOTE
For optimal results, the sensor module must be placed on a supportive
surface with the serial number label facing up. This orientation
provides repeatable measurements by eliminating strain on the input
connector.
The input connector should be torqued to 12 in-lb (135 Ncm) for the
type-N connector, 8 in-lb (90 Ncm) for the APC 3.5 mm connector, or 8
in-lb (90 Ncm) for the 2.4 mm connector to ensure a repeatable
connection in order to meet the published specifications.
Connect the sensor module by turning only the hex nut portion of the
connector. Damage can occur if torque is applied to the sensor module
body.
The connector plastic insulator bead deteriorates when contacted by
acetone, trichloroethylene, carbon tetrachloride, benzene, etc.
WARNING
BEFORE CONNECTING THE SENSOR MODULE TO OTHER
INSTRUMENTS, ensure that all instruments are connected to
the protective (earth) ground. Any interruption of the
protective earth grounding will cause a potential shock hazard
that could result in personal injury and cause damage to the
sensor module.
10
Table 4-3 on page
37. Keep the damaged shipping materials (if
Chapter 2
Advertisement
Table of Contents
