Siemon LightVerse Pro Installation Instructions Manual

LightVerse
Rear
The mounting brackets can be mounted in three positions to
provide different position placement in the mounting rails of a
cabinet or rack.
1
The open hole design of the rack mounting brackets can be utilized
to allow for easier mounting. 1. Screw in mounting screws at desired
height for bottom of the enclosure in the rack. The enclosure can
then be lowered down onto the partially installed screw, tighten
screws. 2. While the enclosure is held in place by the lower screws,
the top screws can then be used to secure it.
Mount enclosure to rack or cabinet
rails using the included #12-24
screws with washers.
3
® Pro Enclosure Installation Instructions
Fron
t
2
1
A D
B C
G
F
E
I
J
K
Hardware and Accessories
A. Fiber Managers (8)
B. Mounting Bracket screws and
washers, 1U (4) 2U and 4U (8)
C. Rear tray restrictor screw (1)
D. Tamper resistant latch keys (2)
E. Laser warning labels (2)
F. Rear guided fiber management
bracket (1)
G. Roll of Velcro straps (1)
H. Velcro dots (2)
I. Tie wraps (2 with the 1U, 4 with the
2U and 4U)
J. Rack 12-24 screws & washers (4)
K. Rear cable plate and screw (1)
Attach mounting
brackets to each side
of enclosure using
mounting bracket
washers and screws
(2 per side for 1U, 4 per
side for 2U and 4U).
2
To open the doors, ensure the tamper resistant latch is not
engaged (if engaged, utilize key and unlock) and grab from
either side or the top.
4
K
H
L
M
Tools
K. Diagonal cutter
L. Philips head screwdriver
M. Flat head screwdriver