Installation Instructions And Instructions For Use - ebm-papst NOVA FLAIR TAIFUN II Premium GreenTech Operating Instructions Manual

Professional nail dust collector
Table of Contents

Advertisement

B
INSTALLATION INSTRUCTIONS AND INSTRUCTIONS
FOR USE
1.
Carefully unpack the nail dust collector
and first check that the black rubber seals
on the edges stick properly.
2.
Place the nail dust collector on the under-
side of the table top and adjust it so that
the cut-out for the ventilation grille is as
central as possible (see sketch).
If anything is unclear, please contact us via the communication channels known to you. It will then be explained
to you again in detail.
Instruction Manual Taifun II Premium GreenTech
Function
The nail dust collector is switched on and off via the
green push button.
The speed control is used for stepless adjustment of
the power. of the power.
Cleaning
Use the hand screws (knurled screws) to loosen the
removable front panel and carefully pull out the acti-
vated charcoal lamella filter slowly using a loop.
For this purpose, it is best to use our additionally
available dust collection tray.
The activated charcoal lamella filters should be taken
8
Nova Flair GmbH & Co. KG, Operating Instructions with EU Declaration of Conformity Dust Extraction Unit Taifun II Premium GreenTech
Kaitstud / Secured by https://mereneid.eu/
3.
Use the jigsaw etc. to make a cut-out in
the centre with a diameter of Ø 160 mm.
4.
Now you can fix the nail dust collector with
suitable screws. (not included in the deli-
very).
Please pay attention to the length of
the screws!
out and cleaned about 2 2-4 times per month. The
remaining coarse dust is simply removed by pulling
out the large dust collection tray (optionally available)
and disposed of. If there is no dust collection tray, the
dust must be sucked out from the inside through the
large filter openings with a hoover and a narrow cre-
vice nozzle attachment or similar.
Also clean or vacuum the lamella filter very carefully
on the lower side only (not the clean air side at the
top). Do not treat it wet and replace it after approx.
one year.
The replacement of the filters and the frequency of
cleaning can vary depending on the effort, care and
customer volume.

Advertisement

Table of Contents
loading

Table of Contents