Attaching The Lens Cap; Cleaning The Projection Lens; Cleaning The Projector Cabinet - Sanyo PLC-XD2200 Owner's Manual

Attaching the Lens Cap

When moving this projector or while not using it over an
extended period of time, replace the lens cap.
Attach the lens cap according to the following procedures.
1
Thread the string through the hole on the lens cap and
then tie a knot in the string to secure it in place.
2
To pass the other end of the string into the hole on the
bottom of the projector and pull at it.

Cleaning the Projection Lens

Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning cloth that
contains a small amount of non-abrasive camera lens
cleaner, or use a lens cleaning paper or commercially
available air blower to clean the lens.
Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents, or other harsh chemicals might scratch
the surface of the lens.

Cleaning the Projector Cabinet

Unplug the AC power cord before cleaning.
Gently wipe the projector body with a soft dry cleaning cloth.
When the cabinet is heavily soiled, use a small amount of
mild detergent and finish with a soft dry cleaning cloth. Avoid
using an excessive amount of cleaner. Abrasive cleaners,
solvents, or other harsh chemicals might scratch the surface
of the cabinet.
When the projector is not in use, put the projector in
an appropriate carrying case to protect it from dust and
scratches.
CAUTION
Do not use any flammable solvents or air sprays on the
projector and in its vicinity. The explosion or fire hazard
may occur even after the AC power cord is unplugged
because the temperature inside the projector is extremely
high due to the lamps. In addition, there is a risk that the
internal parts may be damaged not only by the flammable
air spray but also by the cold air.
Maintenance and Cleaning
61