Advertisement
Setting the Display Parameters of the SCMI-03S Module
The menu for setting the display parameters has the following items
Backlit
Contrast
IdleTime
List of Errors
The menu allows you to view up to the last eight operation errors of the SCMI-03S. When
one or more errors have occurred and you open this menu, the recorded errors are displayed
sequentially (from the latest to the oldest one). For example, if the required temperature is
not kept, the display will show
Err -1
0100
For the duration of the error condition, the output relay is activated; at the same time the red
LED flashes and remains to flash until all errors have been manually cleared. Press the ▼
key to display older errors. If there are no other errors, the display will show
Err -2
----
After displaying and fixing all errors, you can use the ENTER key to delete all stored errors
at once
Delete
Errors? Y
After confirmation, the successful deleting is confirmed by the message
Saved OK
Currently, only the following errors are displayed, others will be added during verification of
the unit functions.
0100
-
The required temperature was not kept.
0001
-
In the combined mode, the AC 1 cannot maintain the desired temperature
0002
-
In the combined mode, the AC 2 cannot maintain the desired temperature
-
Setting of the backlight of the module LCD in 16 levels
-
Setting of the contrast of the module LCD in 16 levels
-
Setting of the idle time after which the LCD default state is restored. You
can select Off or a delay from 30 to 120 seconds
- 5 -
Advertisement
