Playback Mode - The Basics; Viewing Images - Sanyo Xacti VPC-S500 Owner's Manual

PLAYBACK MODE - THE BASICS

Viewing Images

You can display the still images one by one.
1. Rotate the mode dial to
, or
pressing the power switch.
2. Press the button.
The last recorded image appears on
the LCD monitor screen.
Basic information
indicators on the LCD monitor screen.
To see full information display, press
the button.
3. Use the four-way controller (
To view the previous image, press the four-way controller ( ).
To view the next image, press the four-way controller ( ).
• For protected images/movie clips,
in this manual titled "Protecting Images/Movie Clips" for further details.
• For images selected for printing with DPOF setting,
(Refer to the section in this manual titled "Setting the DPOF" for further details.)
• If there is no image stored in the internal memory or on the SD/SDHC memory
card, [No image] message will appear on the LCD monitor screen.
• You cannot enter the Playback mode from the Setup mode.
, ,
and turn your camera on by
is shown
) to select the desired images.
, ,
by
mark will be displayed. Refer to the section
100-0001 100-0001 100-0001
mark will be displayed.
EN-35