Taoglas TGX.04 Series Installation Instructions

Installation Instructions
TGX.04 Series
MIMO 5G/4G Antenna

Introduction

Following these guidelines will help ensure that your Taoglas
TGX.04 antenna is installed correctly. The TGX.04 can be mounted
via 3 different variations; wall mount, pole mount and suction
cup mount. All mounting methods are outlined below.

Installation Requirements

Antenna Components: Mounting Plate (x1), Tightening Nut (x1), Antenna Housing (x1), Coaxial Cable(x4)
Pole Mount
• 7mm [9/32"] socket wrench/ screwdriver
• Metal mounting clamp (x2)
• Pole diameter range: 22mm [0.9"] -
50mm [2"]
Suctions Cups
This antenna should be mounting with suction cups for indoor use only.
Notices
Caution
To comply with FCC RF Exposure requirements in section 1.1310 of the FCC Rules, antennas used with this device must be installed
to provide a separation distance of at least 20 cm from all persons to satisfy RF exposure compliance.
Warning
Do not Operate the transmitter when someone is within 20 cm of the antenna.
Do not operate the equipment in an explosive atmosphere.
European Waste Electronic Equipment Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them away into standard waste.
Directive (RoHS) 2011/65/EU / 2015/863/EU
Harmonised Standards and References:
EN 301 489-1 (V2.2.1): ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical
requirements. Referencing CENELEC EN 55032 Class B.
All copyrights, trademarks and any other intellectual property rights related are owned by Taoglas Group Holdings Limited.
IG-21-8-020-A
Wall Mount
• Screwdriver
• Drill
• M4 [Gauge 8] screw (x4)
• M4 [Gauge 8] washer (x4)
• 6mm [1/4"] wall mount stud (x4)
Suction Cups
• D40 suction cups (x4)
taoglas.com