Taoglas iDAS.C.001 Installation Instructions

Mimo 5g/4g ceiling mount omni-directional antenna

Installation Instructions

iDAS.C.001

MIMO 5G/4G Ceiling Mount Omni-directional Antenna

A Introduction

Following these guidelines will help ensure that your Taoglas

iDAS antenna is installed correctly. The iDAS.C.001 can be

mounted via threaded nut in ceiling tiles or via screw mount in

fixed ceilings. Both mounting methods are outlined below.

B Ceiling Tile Mounting

Unpack the iDAS antenna from the packaging and remove the connector caps from the 4.3-10 mini-DIN

connectors. Unscrew the plastic nut from the base plate thread as per Fig. 1 below.

Prepare the ceiling tile by drilling a ø20mm hole in the desired location. When preparing to drill the hole,

mask the area around the hole position to protect the surrounding surface.

Feed both cables through the hole and plastic nut as per Fig. 2. Connect iDAS cables to the cellular signal

source cables. Screw the plastic nut tight to ensure a good fix on the ceiling tile, FIg.3.

Care should be taken to mount the iDAS antenna as far as possible from other roof-mounted features such as

air-con units, ceiling lights etc. Replace the ceiling tile back into the ceiling panel.

Fig. 1

IG-20-08-002

Fig. 2

Fig. 3

www.taoglas.com

Table of Contents

Need help?

Do you have a question about the iDAS.C.001 and is the answer not in the manual?

Page 1 A Introduction Following these guidelines will help ensure that your Taoglas iDAS antenna is installed correctly. The iDAS.C.001 can be mounted via threaded nut in ceiling tiles or via screw mount in fixed ceilings. Both mounting methods are outlined below.
Page 2 Please ensure that your old Waste Electricals and Electronics are recycled do not throw them away into standard waste. Waiver: This document represents information compiled by Taoglas to the best of our current knowledge. This is not intended to be used as a representation or warranty of fitness of the products described for any particular purpose.