Subscribe to Our Youtube Channel
Related Manuals for Sentera Controls SPV-8-010-CP
Summary of Contents for Sentera Controls SPV-8-010-CP
- Page 1 SPV-8-010-CP 230 VAC POTENTIOMETER WITH MODBUS RTU AND DRY CONTACT Mounting and operating instructions...
- Page 2 INTENDED AREA OF USE TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 2 - 8 www.sentera.eu back to the table of contents...
- Page 3 In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 3 - 8 www.sentera.eu...
- Page 4 MODBUS RTU AND DRY CONTACT PRODUCT DESCRIPTION The SPV-8-010-CP potentiometer is intended for stepless control of EC motors requiring a 0—10 VDC, 0—20 mA or 0—100 % PWM control signal. The minimum output values can be adjusted via Modbus within the ranges: 0—4 VDC / 0—8 mA / 0—40 % PWM and the maximum output values –...
- Page 5 Do the wiring according to the wiring diagram (see Fig. 1 Wiring and connections). Mount the internal enclosure into the wall according to the mounting dimensions shown in Fig. 2 Mounting dimensions - flush mounting. MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 5 - 8 www.sentera.eu...
- Page 6 Customise the factory settings to the desired ones via the 3SModbus software or the Sensistant configurator. For the default factory settings, see the Modbus register map. MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 6 - 8 www.sentera.eu back to the table of contents...
- Page 7 To assure correct communication, the NBT needs to be activated in only two devices on the Modbus RTU network. If necessary, enable the NBT resistor via 3SModbus or Sensistant (Holding register 9). MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 7 - 8 www.sentera.eu...
- Page 8 In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-SPV-8-010-CP-EN-000 - 09 / 07 / 2020 8 - 8 www.sentera.eu...
Need help?
Do you have a question about the SPV-8-010-CP and is the answer not in the manual?
Questions and answers