Cleaning The Projector - ViewSonic Cine5000 User Manual

◆ To reset the lamp timer
1. Press the Menu button on control panel or
Remote Control.
2. Go into the system menu and move the
cursor to the lamp reset item.
3. Select "Yes" to execute the lamp reset and
the lamp hours will reset to 0 hour.
Image Display Audio System Language
OSD Location
Projection
Lamp Hours
Lamp Reset Yes No
Auto Source Yes No
Factory Reset Yes No
Over Scan Video PC
DRAWING 31
◆ IMPORTANT
* Do not touch the lamp immediately after it has
been used: it will be extremely hot. Allow the
fan to finish its cooling process, then turn the
projector off, and disconnect the power cord.
Then allow at least one hour for the lamp to
cool down before handling.
* Do not remove any screws other than the
lamp cover screw and the lamp housing
screws. Removing other screws could result
in electric shock.
* Although the mercury content of the lamp is
minuscule, spent lamps should be treated as
hazardous waste. Consult federal,
state/provincial or local regulations for proper
disposal.
◆ CAUTION
Continuing to use the lamp after the replace
the lamp message has been displayed on the
screen may result in the lamp exploding. If
this occurs, pieces of glass may scatter
inside the projector, and out into the room. If
this occurs, do not touch them, as the pieces
of glass may cause injury. The bulb contains
a small amount of mercury: ventilate the area
well. Contact your dealer for servicing: do not
attempt to service the projector yourself.

4-2-2.CLEANING THE PROJECTOR

◆ Cleaning the cabinet
Turn off projector and unplug the power cord
from the projector before cleaning the outer
cabinet.
Wipe lightly with a soft, dry cloth. If the
cabinet is very dirty, clean it with a soft,
dampened cloth using mild commercial
cleaner and finish with a dry cloth. Do not use
liquid or aerosol cleaners.
50
◆ Cleaning the lens
Clean the lens carefully by using a blower or
lens paper to prevent creating any scratches
on lens.
13