Ramsey Electronics FX Series Manual page 56

to 100K) (R7,S1)
1 10K squelch control potentiometer (R13)
1 12-position rotary switch (S2)
1 3.5 mm. jack, miniature (J2, speaker)
1 2.5 mm. jack, subminiature (J4, microphone)
1 5-pin female DIN PC-mount connector (J1, packet)
1 SO-239 coaxial RF connector (J3)
1 28 pin DIP IC socket (for U6)
1 DC power cord with inline fuseholder and 1A fuse
1 1/2" panel-mount strain relief for DC power cord
1 length of No. 20 bus wire (to make diode matrix bridges)
1 length of No. 24 bus wire (to make L9 and L19)
1 hookup wire, as needed (may include 1,2, or 3 conductors)
3 wire cable ties
1 1/4"x20 bolt (to wind coils on for perfect spacing)
1 document packet, including this manual
REQUIRED, NOT SUPPLIED WITH KIT:
Thin-diameter rosin-core solder
Correct tools for all phases of assembly (see text)
Microphone and speaker per specifications in text (J2,J4 and PTT circuit
are designed for ICOM-type mike)
Fused, 13.5 VDC power supply or battery
50-ohm dummy load
50-ohm 2-meter antenna with PL259 or adapter
OPTIONAL, RECOMMENDED:
Ramsey CFX Transceiver Case and Knob Kit
IMPORTANT:
For proper RF shielding and secure mounting of controls, connectors, and the
PC board, immediate consideration must be given to the transceiver enclosure
as an integral part of the assembly process. The CFX matching case set is the
quality, custom designed finishing touch for your transceiver.