MTI FREEDOM CORE II User Manual page 4

APPLE WATCH KIT INSTALLATION, U.S.
PHOTO INSTALL GUIDE
1
With the MTI logo on the FlexSensor and anchor facing
up, fully insert golden finger end of FlexSensor into the
bottom slot on the anchor housing of the FlexSensor
Cable until the golden fingers are no longer visible and
a slight clicking sound is heard.
3
Remove backing of adhesive on the FlexSensor in
preparation for attaching to back of watch. Firmly
press FlexSensor adhesive side down on back of watch
as shown.
DO NOT PEEL THIS
SECTION AT THIS STEP
5
Wrap loop around and insert end of loop through
anchor housing. Tighten FlexSensor, remove backing
of adhesive and adhere to underside of sensor.
MTI 1050 NW 229th Avenue Hillsboro, OR 97124 PPGsupport@mobiletechinc.com
FREEDOM CORE II™ USER GUIDE
2
Remove backing of adhesive and press firmly onto the
underside of anchor housing.
4
Turn watch over, wrap FlexSensor housing around
watch band.
6
There may be some excess material at the end which
may be trimmed off. Remove Intellikey from Alarm
Module to arm system.
MTI P/N 063-00085 rev A ©2016 MTI All Rights Reserved
4