Table of Contents
Advertisement
•
Keep the cutting attachment below waist level.
•
Keep body parts away from the hot surfaces.
•
Keep body parts away from the cutting attachment.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
•
Do an overhaul inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
To start the product
1. Put the product in the start position.
2. Push and hold the start button until the green LED
comes on.
3. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. Withe the mode button
the operator can limit the maximum speed. The mode
button has 3 speed levels. A lower level increases the
14
time of operation for the product. The mode button has
3 speed levels. A lower level increases the time of
operation for the product. Use level 1 and level 2 if the
operation does not require full speed/full power. If the
operation condition requires full speed/full power, use
level 3. Do not use a higher level than necessary for the
operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on.
2. Push the Mode button again to choose the next
speed level.
Automatic shutdown function
The product has a shutdown function that stops the
product if the product is not used. The green LED for
start/stop indication goes off and the product stops after
180 seconds.
Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle.
Do not push the grass trimmer line into the grass.
2. Decrease the length of the grass trimmer line by
10-12 cm (4-4.75 in) and decrease the motor speed
to decrease the risk of damage to plants.
1938 - 003 - 24.02.2023
Advertisement
Table of Contents
