KlipXtreme KPM-321 Quick Start Manual

Lcd/led triple monitor mount

Download this manual

KPM-321

Introduction:

Thank you for purchasing the KPM-321 LCD/LED triple monitor mount. This product is

shipped with all proper installation hardware and components. Upon opening the box, make

sure that none of these parts are missing and/or damaged before beginning installation.

1. Hardware kit

Label

Image

Item

Desktop base

Shaft

Mounting arm

VESA center plate

Cable clip

Cable clip with tool holder

Decorative shaft cap

3mm allen wrench

5mm allen wrench

LCD/LED triple monitor mount

Articulated

joints

Heavy-duty

desktop base

Quantity

Need help?

Do you have a question about the KPM-321 and is the answer not in the manual?

Page 1 Introduction: Thank you for purchasing the KPM-321 LCD/LED triple monitor mount. This product is shipped with all proper installation hardware and components. Upon opening the box, make sure that none of these parts are missing and/or damaged before beginning installation.
Page 2 • KlipXtreme does not warrant against damage caused by the use of any KlipXtreme mounts for purposes other than those for which it was designed or damage caused by unauthorized...
Page 3 2. Then insert the center VESA plate onto the shaft and secure it by fastening the clamp bolts with the supplied allen wrench. 5. Attaching the mounting arm assembly 1. Once you have completed the installation steps described above, slide the mounting arm assembly onto the shaft and tighten the clamp bolts at the desired height.
Page 4 3. Attach all six cable clips on the arms. Verify the adequate thread engagement of the screw/washer combination on CAUTION: your monitor. Too short will not hold the display and too long will damage it. Too short Correct Too long Attention: Two people might be needed to complete the steps below.
Page 5 5. 75x75 VESA monitors must be attached directly from behind the mount. Hold the display 3. Fully tighten the screws of the joints when the optimal viewing angle is reached. The with both hands to align the threaded inserts on the back panel with the ones on the plate. monitors can be also rotated for portrait or landscape orientation, or anything in between.
Page 6 Notes Notes...