Table of Contents
Advertisement
FAULT
Unsat sfactory wash ng
result.
As soon as the mach ne s
loaded w th water, water
d scharges.
No water appears n the
drum dur ng wash ng.
Laundry has
detergent res due.
Grey spots appear on the
laundry.
The sp n cycle does not take
place or takes place later
than expected.
(*) See the chapter regard ng ma ntenance and clean ng of your mach ne.
(**) See the chapter regard ng nstallat on of your mach ne.
10. AUTOMATIC FAULT WARNINGS AND WHAT TO DO
Your Wash ng Mach ne s equ pped w th a bu lt- n fault detect on system, nd cated by a
comb nat on of flash ng wash operat on l ghts. The most common fa lure codes are shown
below.
TROUBLE CODE
Wash
The door of your mach ne s not shut
Rinse
E01
Spin
End
Wash
The water pressure or the water level
Rinse
E02
Spin
End
Wash
Rinse
E03
clogged or electr cal connect on of the
Spin
End
Wash
Your mach ne has excess ve amount of
Rinse
E04
Spin
End
(*) See the chapter regard ng ma ntenance and clean ng of your mach ne.
POSSIBLE CAUSE
Hard water.
Your laundry s too t ghtly packed
together n the drum.
The end of water dra n hose s too
low for the mach ne.
No fault. Water s n the unseen
part of the drum.
Non-d ssolv ng part cles of some
detergents may appear on your
laundry as wh te spots.
There s untreated o l, cream or
o ntment on your laundry.
No fault. The Unbalanced load
control system has been act vated.
POSSIBLE FAULT
properly.
ns de the mach ne may be low.
The pump s faulty or pump f lter s
pump s faulty.
water.
Increase the amount of detergent follow ng the
Check that your laundry s spread out.
Check that the dra n hose s at a su table he ght.
Perform an extra r nse, or clean your laundry w th
Use the amount of detergent as nstructed on the
packag ng n the next wash.
The Unbalanced load control system w ll try to
spread your laundry. The sp nn ng cycle w ll beg n
once your laundry s spread. Load the drum
Shut the door properly unt l you hear a cl ck. If
your mach ne pers sts to nd cate fault, turn off
your mach ne, unplug t and contact the nearest
author sed serv ce agent mmed ately.
Check the tap s fully turned on. Ma ns water
may be cut-off. If the problem st ll cont nues, your
mach ne w ll stop after a wh le automat cally. Unplug
the mach ne, turn off your tap and contact the
nearest author sed serv ce agent.
Clean the pump f lter. If the problem pers sts,
contact the nearest author sed serv ce agent. (*)
Your mach ne w ll d scharge water by tself. Once
the water has dra ned, turn off your mach ne and
unplug t. Turn off the tap and contact the nearest
author sed serv ce agent.
EN - 25
TROUBLESHOOTING
manufacturer's nstruct ons.
(**) .
. . . . . . . . . . . . . . . . . . . . .
a brush after t dr es.
evenly for the next wash.
WHAT TO DO
Advertisement
Table of Contents
