Table of Contents
Advertisement
3. INSTALLATION
3.1 Remov ng the Trans t Bolts
4
X
4
X
1. Before operat ng the wash ng mach ne,
remove the 4 trans t bolts and rubber
spacers from the rear of the mach ne.
If the bolts are not removed, they
may cause heavy v brat on, no se and
malfunct on of the mach ne and vo d the
warranty.
2. Loosen the trans t bolts by turn ng
them ant clockw se w th an appropr ate
spanner.
3. Remove the trans t bolts w th a stra ght
pull.
4. F t the plast c blank ng caps suppl ed n
the accessor es bag nto the gaps left
by the removal of the trans t bolts. The
trans t bolts should be stored for future
use.
NOTE:
Remove the trans t bolts
before us ng the mach ne for the f rst t me.
Faults occurr ng due to the mach ne be ng
operated w th trans t bolts f tted are out of
the scope of the warranty.
1
3
3.2 Adjust ng the Feet /
Adjust ng Adjustable Stays
4
X
2
1. Do not nstall your mach ne on a surface
(such as carpet) that would prevent
vent lat on at the base.
To ensure s lent and v brat on-free
operat on of your mach ne, nstall t on a
f rm surface.
You can level your mach ne us ng the
adjustable feet.
4
Loosen the plast c lock ng nut.
2. To ncrease the he ght of the mach ne,
turn the feet clockw se. To decrease
the he ght of the mach ne, turn the feet
ant clockw se.
Once the mach ne s level, t ghten the
lock ng nuts by turn ng them clockw se.
3. Never nsert cardboard, wood or other
s m lar mater als under the mach ne to
level t.
When clean ng the ground on wh ch
the mach ne s located, take care not to
d sturb the level of the mach ne.
3.3 Electr cal Connect on
Your Wash ng Mach ne requ res a 220-
240V, 50Hz ma ns supply.
EN - 9
4
X
2
1
3
Advertisement
Table of Contents
