Troubleshooting - ProBreeze PB-IM01 Instruction Manual

TROUBLESHOOTING

― ―
If a power cut occurs due to disconnection of the power cord, unexpected pushing of the POWER
button during an ice-making cycle or power blackout, the already formed ice on the evaporator
will not fall immediately but keep sticking to the evaporator. Under this circumstance, please
disconnect the power cord and gently push the shovel to the rear of the ice-making cabinet, then
power on again, and let the ice fall by itself before pressing the POWER button to restart the ice-
making cycle.
Problem
Constant buzzing noise
Add water light on
The indicator lights on the
control panel are not on
No ice produced
Incapable of making ice
All indicators light up
simultaneously
14 of 112 | English
Cause
The voltage is lower than the
recommended value
There is no water
There is water, but not
enough
The conductivity of the water
used is too low
No power
The compressor has no
refrigerant
The compressor is damaged
The motor's fan is damaged
The water collecting box is
blocked by ice
Motor error
Microswitch damage
Sunlight interference
Solution
Stop the ice maker, check
if the household voltage
is consistent with the
recommended value
Add water until it reaches the
MAX position. Press the power
button twice to restart
Do not use ultrapure water or
distilled water
Plug the unit in and turn the
power on. If the appliance
does not turn on after this,
contact customer care
Contact customer care
Contact customer care.
Unplug the appliance,
remove the ice, then plug in
the appliance and press the
power button to restart that
appliance.
Contact customer care
Set the machine away from
direct sunlight