Operating Instructions - ProBreeze PB-IM01 Instruction Manual

Power button
Select button
Self-Cleaning
function
Add water
Ice full

OPERATING INSTRUCTIONS

― ―
Getting Started
WARNING: WHEN SWITCHING ON THE ICE MAKER FOR THE FIRST TIME OR AFTER STORAGE,
PLEASE ALLOW THE UNIT TO STAND FOR TWO HOURS FOR THE REFRIGERANT TO SETTLE.
Before first use: please thoroughly clean the ice maker and all accessories provided (please refer
to the cleaning and storage section for instructions).
Making Ice
1. Open the lid of the ice maker and remove the ice collecting tray.
2. Fill the water reservoir up to the MAX line with potable water only.
3. Place the ice collecting tray back into the ice maker.
4. Plug in the power and press the power button to turn the appliance on.
5. Press the select button to choose between small ice or large ice mode.
6. Once your mode has been selected the process shall begin.
7. Upon completion the appliance will enter standby mode.
Note: the ice produced would be smaller and irregular in the first five cycles of the machine.
10 of 112 | English
Upon plugging in the ice maker the appliance will be in standby
mode. Press the power button to turn the appliance on.
The select button allows you to choose between small or large ice
as well as self-cleaning functions. Plug in the ice maker and switch
on the appliance by pressing the power button. Then choose your
function by pressing the select button. The corresponding function
light will flash for five seconds, and the appliance will process this
function.
Plug in the power and press the power button to turn on the
appliance. Press the select button once and choose the self-
cleaning function. The self-cleaning indicator will light up for five
seconds and then the process of self-cleaning will begin.
The add water indicator light flashes when there is not enough
water in the water tank to carry out the ice-making process. Refill
the water tank and then press the power button to restart the
appliance.
The ice full indicator light will light up when the ice collection tray
reaches maximum capacity. When this happens, the machine will
enter standby mode. Use the ice scoop to remove the ice from the
collection tray. Once the tray is empty, the appliance will restart
automatically.