Table of Contents
Advertisement
Available languages
Available languages
Note: due to fast freezing, ice cubes may opaque. This is air trapped in the water and will not
affect quality or taste of ice.
Self-Cleaning Mode
WARNING: THE SELF-CLEANING FUNCTION WILL NOT WORK WHEN IN 'STANDBY MODE'.
WARNING: DO NOT TURN OFF OR UNPLUG THE UNIT WHEN IN SELF-CLEANING MODE.
1.
Open the lid of the ice maker and remove the ice collecting tray.
2.
Fill the water reservoir up to the MAX line with a solution of water and vinegar in a 1:1 ratio.
3.
Plug in the power and press the power button to turn the appliance on.
4.
Press the select button to choose the self-cleaning mode.
5.
Wait for 5 seconds and then the function will begin. Upon completion, the appliance will enter
standby mode.
6.
Unplug the unit and drain the water tank of the cleaning solution (see instructions below)
7.
Fill the water reservoir up to the MAX line with water.
8.
Plug in the power and press the power button to turn the appliance on.
9.
Press the select button to choose the self-cleaning mode.
10.
Wait for 5 seconds and then the function will begin.
11.
Upon completion the appliance will enter standby mode.
12.
Unplug the unit and drain the water tank of the cleaning solution (see instructions below)
Draining The Water Tank
1.
Unplug the ice maker and empty the appliance of all ice.
2.
To drain the appliance of any excess water, move the appliance so the drain tube plug under
the front housing is over the work surface. Note – when moving your ice maker, please ensure
the appliance stays upright.
3.
Place a receptacle underneath the drain tube unplug the plug and allow all the liquid to flow
out.
4.
Reattach the drain tube plug.
5.
Either dry the interior of the appliance with a dry, clean cloth. Or leave the appliance with the
lid open to dry.
CLEANING
― ―
WARNING: ENSURE THE APPLIANCE IS SWITCHED OFF
AND UNPLUGGED FROM THE ELECTRICAL OUTLET BEFORE
HANDLING, FILLING WITH WATER AND CLEANING.
English | 11 of 112
Advertisement
Table of Contents
